Table of Contents
Advertisement
2
Installing the Nokia IP1200 Series Appliance
Figure 9 Rack-Mounting Screw Locations
Two rack-mounting positions allow you to mount the appliance either flush with the rack, or four
inches forward of the equipment rack. If the space behind the rack is insufficient, the rack
mounting brackets can be attached further back on the side of the appliance.
Caution
During installation, do not block any ventilation openings. Doing so might result in
damage to the appliance when it is turned on.
Before You Begin
To rack-mount the appliance, you need:
Phillips-head screwdriver
Disposable grounding wrist strap
Suitable, grounded work surface on which to place the chassis tray assembly
Before you rack mount the appliance, you can ground it by using the grounding lugs provided.
To ground the IP1200 Series
1. Locate and remove from the package the #6 ring tongue lugs and kep nuts.
2. Attach a 10 or 12 AWG insulated grounding cable to the lugs.
3. Locate the two threaded grounding studs protruding from the rear panel of the appliance, as
shown in
4. Slide the grounding lug loops over each of the studs.
5. Secure the grounding lugs by threading the nuts onto each of the studs until they are tight.
You can use an adjustable wrench or similar tool to finish tightening the nut onto the stud.
Do not over tighten the nuts.
6. Attach the grounding cable to an earth ground or other grounding point to meet the
specifications of your installation site.
34
All manuals and user guides at all-guides.com
Rack-mounting screw locations
Figure 6
on page 26.
IP1220 and IP1260 Security Platforms Installation Guide
00307a.3
Advertisement
Table of Contents
