Sony DSC-WX50 Service Manual page 17

Put down the Shield Ring (AB) into the Cam Tube Block Assy.
8
Note: Put down the Shield Ring (AB) so that the pet side comes to the Eyepiece side.
Install the Tube Lubricating Block Assy while aligning the bayonet beside the number inside the Cam Tube Block Assy
9
with the groove of the Tube Lubricating Block Assy.
Turn the Tube Lubricating Block Assy to align the U cutout and the convex part of the Tube Lubricating Block Assy.
q;
Note: Make sure that the number on the Tube Lubricating Block Assy and the number on the Cam Tube Block Assy
come to the positions shown in the figure below.
Tube Lubricating
Block Assy
Shield Ring (AB)
Pet Side
Groove
Cam Tube
Block Assy
Cam Tube
Block Assy
Inside View
Number
Bayonet
Set the Hole for Barrier Lever on the 1 Group Assy and the number on the Tube Lubricating Block Assy to the positions
qa
shown in the figure below, and then install the 1 Group Assy while inserting the three ledges of the 1 Group Assy into
the three ditches of the Tube Lubricating Block Assy.
1 Group Assy
1 Group Assy
Ledge
Hole for
Barrier Lever
Ditch
Number
DSC-WX50_L2
Eyepiece Side View
Tube Lubricating
Block Assy
Convex Part
U Cutout
Inside View
Number
Hole
Number
Eyepiece Side View
Ledges
Ditches
Tube Lubricating
Block Assy
Align the end of the Iris Flexible Board with the number on the Tube Lubricating Block Assy, and then install the Frame
qs
Block Assy (1430A) while inserting the three ledges of the Frame Block Assy (1430A) into the three ditches of the Tube
Lubricating Block Assy.
Frame Block Assy (1430A)
Tube Lubricating
Block Assy
Set the lens to the TELE state and then affix the Shield Ring (D).
qd
Note: Affix the Shield Ring (D) with equal gap without overlapping with molded parts.
Shield Ring (D)
Eyepiece Side View
1-14
Eyepiece Side View
Iris Flexible
Frame Block
Board
Assy (1430A)
Ledges
Ditches
Tube Lubricating
Number Block Assy
Shield Ring (D)