Table of Contents
Advertisement
3-6-3. Installing the Shipping Plates A and B
to the Rear Panel
Shipping plates A and B can also be installed to the rear
panel of PDJ-A640 after being removed.
Install the removed shipping plates A and B as shown
below in order not to lose them.
1. Remove shopping plate A. (Refer to Section 3-6-1.)
2. Remove the four screws (A and B). Then, remove
shipping plate B. (Refer to Section 3-6-2.)
3. Install shipping plates A and B to the rear panel of
PDJ-A640 with the removed screws.
n
Install the two fixing screws of shipping plate A to the
counter weight in order not to lose them. (Refer to
Fig.2 in Section 3-6-1.)
Shipping plate
A
Shipping plate B
Shipping plate
Hexagon socket
bolt M4 x 6
PDJ-A640 IM
System control unit
A
Shipping plate B
3-6-4. Moving the Shipping Ring
1. Open the door. (Refer to Section 3-2-2.)
2. Loosen the screw on the shipping ring (upper). Move
the shipping ring (upper) up to the stopper on the Y-
axis shaft, and then tighten the screw to fix it.
3. Loosen the screw on the shipping ring (lower). Move
the shipping ring (lower) down to the stopper on the
Y-axis shaft, and then tighten the screw to fix it.
Stopper
Screw
Screw
Stopper
Shipping ring (upper)
Y axis shaft
Shipping ring (upper)
Elevator block
Shipping ring (lower)
3-7 (E)
Advertisement
Table of Contents
