Connecting The Tc-Net 100 Cable - Toshiba nv-pack Series Instruction Manual

2.2

Connecting the TC-net 100 Cable

Connect the TC-net 100 cable (optical fiber code) to the JTNI.
CAUTION
CAUTION
CAUTION
Connecting the optical fiber cord
Connect the optical fiber cord to the MT-RJ type optical connectors (TN-A and
TN-B) as shown below.
Remove the dust cover of the optical connector.
Remove the dust cover of the optical connector. Pinch the dust cover with
your fingers until it clicks, and then remove it.
Connect the optical fiber cord.
Insert the optical fiber cord into the MT-RJ type connector, and press it in
until it clicks.
Secure the cable.
Secure the cable by clamping it so that no stress is exerted on the cable.
Before installation or wiring, remove the static
electricity from your body.
The static electricity accumulated in the human body
may cause failure of the product.
Do not touch the cables carelessly.
Applying stress to the cables may cause
malfunction or accidents.
Perform a notification check in the application
level using the transmission protocol.
When an error occurs such as unable to turn on the
power, stop using and contact one of Toshiba's service
representatives.
If you have any question, consult with one of Toshiba's
service representatives.
Unified Controller nv-pack series TC-net 100(JTNI)Extended card Instruction Manual
2.2 Connecting the TC-net 100 Cable
Mandatory
Prohibited
Mandatory
9