Miele KM 3034 Operating And Installation Instructions page 37

Problem
The gas flame goes out
during operation.
The ignitor on the
burner does not spark.
The in-operation /
residual heat indicator
for a cooking zone is
flashing.
Letters appear in the
minute minder display.
Possible cause and remedy
The burner components are not positioned correctly.
 Position the burner components correctly.
There has been a power cut.
 Turn all control knobs clockwise to the  position.
When the power supply is restored, the cooktop
can be operated again as usual.
The mains circuit breaker has tripped.
 If it has, contact a qualified electrician or Miele.
There is food residue stuck between the ignitor and
the burner cap.
The flame failure device is dirty.
 Remove any soiling (See "Cleaning and care").
There has been a power outage.
 Turn all control knobs clockwise to the  position.
When the power supply is restored, the cooktop
can be operated again as usual.

The system lock has been activated.
 You need to deactivate the system lock (see
"System lock").

A sensor fault has occurred.
 Make sure that there is no direct light (from the sun
or from an artificial source) falling onto the
cooktop. The area surrounding the cooktop must
not be too dark.
 Make sure that there is nothing covering the
sensors or the cooktop. Take any pans off the
cooktop and wipe away any food deposits.
 Interrupt the power supply to the cooktop for
approx. 1 minute.
 If the problem persists after power is restored,
please contact Miele.
Problem solving guide
37