Reset The Set Position Points To The As Delivered Condition; Switch Off The Training System - Bosch WS502 Instruction Manual

Robotics Trainings System WS502
10.15 Reset the set position points to the as delivered
condition
To reset position points to the as delivered condition proceed as follows:
In the main screen:
Press the Position Screen button.

The position data screen opens.
Press the Setup Screen button.

The Setup screen opens.
Press the Restore button.

The data is displayed in the as delivered condition.

10.16 Switch off the training system

Proceed as follows to switch off the training system.
In the main screen:
Press the Automatic Stop button to stop the automatic program

Wait until the robot is at a standstill.

Turn the main switch to the "0 - Off" position.

The Bosch Rexroth control is immediately switched off.
The robot system is shut down through an uninterruptible power supply (UPS)
and then turned off.
After the cooling fan on the robot control cabinet has been switched off wait
approx. 30 seconds before switching on again.
Bosch Rexroth AG 49/64
Operation of the training system