GE LOGIQ E9 Service Manual page 267

GE
D 5573152-100, R
IRECTION
7-5-9 Diagnostics - BEP
For Diagnostic differences, see
71.
7-5-9-1 Essential Tests
See:
7-5-3 "Diagnostics Window Overview" on page 7-16
Runs tests on essential functions of the BEP. This is a good starting point for isolating issues that may
originate from the BEP. The test results are displayed in the Status portion of the window.
Run Time: About 2 minutes.
1.) Enter the desired Loop Count (numeric value of 4 digits or less).
2.) Click the Execute button.
3.) Failed tests may have another diagnostic test that can help isolate the failure, or will indicate which
part to replace. For:
-
-
-
-
-
-
7-5-9-2 Essential Tests differences in R4 and later
Essential test in R4 has two versions:
• Essential test: Complete test, same as R3 or earlier
Essential test, No network: same test, except it does not run the network tests for wired or wireless
connection.
7-5-9-3 System Board
See:
7-5-3 "Diagnostics Window Overview" on page 7-16
Runs tests on essential functions of the PC Mother Board. The test results are displayed in the Status
portion of the window.
Run Time: About 1 minute.
1.) Enter the desired Loop Count (numeric value of 4 digits or less).
2.) Click the Execute button. If there are any failures:
3.) Check the Motherboard Harness. Swap with a known good harness. If the problem continues:
4.) Replace the Motherboard. If the problem continues:
5.) Replace the BEP.
. 2
EV
7-5-11 "Diagnostics - BEP Interactive Tests - R4.x and later" on page 7-
PCI Bus configuration
CMOS memory
CPU - run
7-5-9-3 "System Board" on page 7-65
RAM - run
7-5-9-12 "Memory" on page 7-69
Hard Drive status and Random Seek - run
and run
7-66 7-5-9-5 "Hard Disk Drive Quick Test" on page 7-66
Network Interface (loopback only) - run
Chapter 7 Diagnostics/Troubleshooting
for a description of this window's features.
7-5-9-4 "Hard Disk Drive Surface Scan" on page
7-5-9-10 "Network Adapter" on page
for a description of this window's features.
LOGIQ E9 S M
ERVICE ANUAL
7-69.
7 - 65