Replacing The Fuse - GE DigitalFlo XGM868i Service Manual

4.4 Replacing the Fuse

Note: This procedure applies only to the fuse on the DC power supply. The fuse on the AC power supply is not
field-replaceable; please consult the factory for replacement.
If it has been determined that the fuse in the XGM868i has been blown, complete the following steps to install a new
fuse:
1. Complete the steps in Removing the Circuit Board Assembly on page 24.
2. Place the circuit board assembly on its side, with the terminal board on the left and the interconnect board on the
right. Rotate the assembly until the power supply board is facing upward.
3. Locate the fuse along the left side of the power supply board, just below the terminal board (refer to Illustration 6 in
Figure 7 on page 34).
4. Pull the plastic cover off the fuse holder and remove the old fuse.
5. Obtain a new fuse of the same rating and type. Use only a type 3AG (1-1/4" x 1/4") Slo-Blo fuse, having a rating as
indicated in Table 4.
6. Press the new fuse into the fuse holder and reinstall the plastic fuse cover.
To complete the fuse replacement, proceed to Installing the Circuit Board Assembly on page 32.
Note: Be sure to record the fuse replacement in Appendix A, Service Record.
DigitalFlow™ XGM868i Service Manual
Table 4: Line Voltages & Fuse Ratings
Line Voltage
12-28 VDC
Fuse Rating
2.0 A, Slo-Blo
Chapter 4. Parts Replacement
27