Table of Contents
Advertisement
Rear panel
1. Remove the top plate (A). (Refer to the "Top plate".)
2. Disconnect the cable ([BLU]) and the cable ([GRN])
from the BNC connectors.
n
When the option board is installed, disconnect the
cables of the option board at the same time.
3. Remove the 10 screws and remove the rear panel in
the direction of the arrow in the way as if disengaging
claws from the holes.
Rear panel
BVTT3 x 8
Claw
BVTT3 x 8
MAV-555A
Cable ([BLU])
Cable
([GRN])
BNC connectors
Claw
Hole
BVTT3 x 8
3-2. Removing the Cabinet
3-5 (E)
Advertisement
Table of Contents
