Toshiba e-STUDIO2010AC Imaging Manual page 78

2.Copier-specific Adjustments
(1) Press [Image] tab on Copy mode. Press [One Touch Adjustment].
Press [Vivid] and then press [OK].
After selecting the "Vivid" option, copy and check the copy image quality.
When the copy image quality with the "Vivid" option is insufficient, cancel the "Vivid" option and
perform the next procedure.
(The one-touch adjustment can be canceled by pressing [Reset].)
(2) Perform saturation adjustment to adjust the overall saturation.
Use steps (a) through (d) to perform the adjustment.
(a) Press [Image] on Copy mode.
(b) Press [Saturation].
(c) Press [+] to increase the saturation of the copy image.
(d) Press [OK].
After adjusting the saturation, copy and check the copy image quality.
If further image quality adjustments are still necessary, perform the next procedure.
(3) Perform color balance adjustment or RGB adjustment to adjust the tint of colors in general.
For further information regarding the adjustment procedures, refer to procedure (3) in "2.3 To
Closely Match the Color Balance of the Original"
After adjusting the tint of colors, copy and check the copy image quality.
If further image quality adjustments are still necessary, the service technician must perform the next
procedure.
(4) Select [05 ADJUSTMENT MODE]. Change the setting values for codes [7675 to 7681] to adjust the
saturation level.
Original mode
Text/Photo
Text
Printed Image
Photo
Map
User Custom
Red Seal Color
• Set the value in increments of approx. 15 steps while checking the copy image until the optimum
value is obtained.
• Each setting value for the Text/Photo, Text and Photo (developing paper) original mode is
reflected to the quality of the image in the Full color and Auto Color modes.
• The subcode varies according to the area where the hue is adjusted. Set the subcode for the area
to be adjusted by referring to the following below.
© 2018 TOSHIBA TEC CORPORATION All rights reserved
[05]code Subcode
05-7675
05-7676
05-7677
05-7678 0/1/2/3/4/5
05-7679
05-7680
05-7681
2-24
Recommended value
0 to 255
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
Default
128