Toro 30284 Service Manual page 205

LINKAGE
20. With the right control lever in the operating position,
there should be .10" (2.5mm) gap between the OPC
switch plunger and the control arm tab. Adjust the
switch location as needed (Fig. 0672).
4
21. Install the spring onto the right hand motion control
lever assembly (Fig. 0673).
4-98
Fig 0672 PICT-2104
Fig 0673 PICT-2071
22. Insert the upper end of the control linkage rod into
the tab on the control handle (Fig. 0674).
Fig 0674
23. Slide a washer onto the upper end of the control
linkage rod (Fig. 0675).
Fig 0675
Floating Deck Mid-Size Service Manual
PICT-2066
PICT-2065