5 USER GUIDE
5.3 Using the FL.NET Module
5.3.1 Link parameter setup procedure
The link parameters are used to set up the FL.NET module common memory area for each node.
Use the setup tool named [S10V FL.NET SYSTEM] to perform link parameter setup. The self-
node setup screen is shown below.
The "Current value" section shows the current settings for the FL.NET module.
To change the settings, enter desired values in the "Rewriting value" section and click the
Write
button. The newly entered link parameter settings are then saved in the FL.NET
module.
New link parameter input area
Current link parameter
Figure 5-32 Link Parameter Setup Window
5-31