Relay - Siemens HiPath 1100 Series Programming Manual

Relay and Sensor on the HiPath 1120
Step by Step
132

Relay

The relay can be activated via the sensor, assuming that
the sensor is configured. It can be activated manually or
automatically after a specified time. When the relay is
activated, the contacts close. When it is deactivated,
the contacts open.
By default, the relay is set to Switch Mode.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
7 5
... Select the operating mode for the relay:
1 5
= "Switch": The relay can only be turned on from an
1
extension by entering the proper feature code
(see Miscellaneous Functions - Relay in the User
Manual).
= "Monoflop": The relay is closed for a specified
2
length of time. Alternatively, the relay can also be
opened before the set time, by entering the prop-
er feature code (see Miscellaneous Functions -
Relay in the User Manual).
= "Switch": The current state of the really is reversed
3
when the feature code for activating the Relay is
selected at an extension.
= "Music on Hold": The Relay can be used for acti-
4
vating external equipment connected for playing
announcements/music.
= "External signal": It is possible to use the relay to
5
control a second ring from an analog extension.
Initial state for Programming Mode.
When playing music from an external music
source, it is required that all regulations related
to copyrights for the country in question are
followed.