Advertisement
1-5. Removing and Installing the DVP Board Assembly
1-6. Installing the CBK-MB01 (MY-113 Board)
Reinstallation
1. Raise the board lever to its upright position.
2. Insert the DVP board assembly in a slant angle until
the protruded portion of the PC board holder (F) meets
the recessed portion of the DVP-34 board. At the
above angle, raise the DVP board assembly in the right
angle and insert it.
3. When shaft of the board lever enters into the chassis,
slant the board lever and push down the board from its
top until it is firmly inserted to the board-to-board
connector of the MB-1032 board.
4. Reinstall it by reversing the steps of disassembling.
1-6 (E)
1-6. Installing the CBK-MB01
(MY-113 Board)
Install the CBK-MB01 to the side-A of the DVP-34 board.
Installation Procedure
1. Insert the connector (CN101) of the CBK-MB01 (MY-
113 board) into the connector (CN101) on the DVP-34
board firmly.
2. Attach the CBK-MB01 with the two precision screws
(P1.4 x 3.5) supplied.
n
Standard tightening torque value :
DVP board assembly
Precision screw
P1.4 x 3.5
Precision screw
P1.4 x 3.5
12 x 10
_2
N.m (1.2 kgf.cm)
DVP-34 board
CBK-MB01
CN101
CN101
CBK-MB01
Advertisement
