Advertisement
1-5. Removing and Installing the DVP
Board Assembly
Removal
1. Open the inside panel assembly. (Refer to Section 1-3.)
2. Remove the DCP board assembly. (Refer to Section 1-4.)
3. Disconnect the flexible card wire from the EQ-88
board connector (CN101).
m
. Life of flexible card wire will be significantly
shortened if it is folded. Be very careful not to fold
the flexible card wire.
. If the copper plating of the base material exposes
due to wear of the tin plated contact of the connec-
tor, replace it with the new flexible card wire.
CN101
Flexible card wire
CBK-MB01
EQ-88 board
1-5. Removing and Installing the DVP Board Assembly
4. Open the board lever in the direction of arrow A and
remove the board-to-board connector that is connected
to the MB-1032 board.
5. Raise the DVP board assembly in the direction of arrow
B by about 15 mm and align the protruded portion of the
board holder (F) with the recessed portion of the DVP-
34 board.
B
Board lever
A
Protruded
portion of
the board
holder (F)
Recessed
portion of
the DVP
board
assembly
6. Slant the DVP board assembly to the front and remove it.
Board lever
DVP board
A
assembly
Board-to-board
connectors
MB-1032 board
DVP board
assembly
1-5 (E)
Advertisement
