Default Settings; Wifi Credential Defaults; Network Defaults - Philips Hadco ZoneScape 1-A Documentation

Default settings

Every ZoneScape unit is configured by default to serve a 802.11 b/g/n access point.
When in AP mode the ZoneScape Ethernet interface is switched off. If the user want
to use the interface, the network mode should be changed to either "Default" or
"Other" in order for the Ethernet interface to be enabled. The AP mode allows the
user to connect to the ZoneScape via WIFI and obtain an IPv4 address via DHCP.

WIFI credential defaults

SSID: ZoneScape_xxxx ( where xxxx is a number that identifies every Zonescape unit)
KEY: 12345678

Network Defaults

Every unit is configured to serve IPv4 addresses via DHCP. Once a device /
Smartphone connect to the unit via Wi-Fi the unit assigns an IP address to the
connected client via DHCP.
Every ZoneScape unit comes preconfigured with the following IP / PORT settings:
 IP: 192.168.16.254
 PORT: 8080
The above network parameters are needed for the ZoneScape app to communicate
with the ZoneScape hardware.
The above defaults can be changed via the unit's web configuration interface which
can be accessed by visiting http://192.168.16.254 .
The web configuration interface is password protected with the following defaults:
 username : admin
 password: admin
The Web configuration interface would allow pairing multiple ZoneScape units
together by setting one of the units in Wireless AP mode (default in every unit) and
the rest of the units in Client mode Wireless.
ZoneScape 1-A module documentation
.
Proposal Page 4 of 28