Side (Right) - Panasonic Live Production Suite Series Operating Manual

7 <COM1 (M)> terminal (connector: D-sub 9-pin (female), inch screw/signal: RS-422)
Used for master connection of external devices.
This terminal cannot be used with the Live Production Suite series.
8 <COM2 (RS-232)> terminal (connector: D-sub 9-pin (male), inch screw/signal: RS-232)
Used to control external device.
This terminal cannot be used with the Live Production Suite series.
9 <GPI I/O> terminal (connector: D-sub 25-pin (female), inch screw/signal: GPI)
Equipped with 8 contact input ports (GPI IN) that control the unit externally, 10 output ports (GPI OUT) that output tallies or status information from
the unit, and an alarm output port (ALARM OUT).
This terminal cannot be used with the Live Production Suite series.
10 <F1>/<F2> terminals
(Fuse)
11 <SIGNAL GND> terminal (signal: SG)
Connects to the ground of the system.
NOTE
@
t For the cable connecting to the <DVI-D> terminal, use a double-shielded cable.
t For the cable connecting to the <MAIN FRAME> terminal, use a shielded cable.

Side (right)

r AV-HS60C2
r AV-HS60C4
1 Reset switch
The reset switch for the Control Panel. (For maintenance)
2 Service switch
The switch for maintenance. Normally use it by setting to forward.
Chapter 3 Part Names and Functions — Control Panel AV-HS60C2/AV-HS60C4
(Front)
(Front)
(Rear)
12
1 2
– 30 –
(Rear)