Entering The Component Topology And Configuring The Drive Unit Automatically - Siemens SINAMICS S120 Getting Started

Creating the Drive Project ONLINE
5.3 Entering the component topology and configuring the
drive unit automatically
Once you have created the project and entered the drive unit with its PROFIBUS
address ONLINE, you have to enter the associated component topology and drive
unit configuration ONLINE.
1. Select the drive unit
Drive_Unit_Addr8.
Fig. 5-6
1. Select the drive unit Drive_Unit_Addr8 in the project navigator.
2. Choose Connect to target system. An ONLINE connection is established.
5-64
2. Choose Connect to target
system.
Project_1
SINAMICS S120 Getting Started with the STARTER Commissioning Tool – 04.2004 Edition
 Siemens AG, 2004. All rights reserved