Series Machine Startup; Introduction - Siemens SINUMERIK 840D sl Commissioning Manual

Series machine startup

11.1

Introduction

The "Series machine startup" function is primarily responsible for backing up the data
belonging to a controller. It is also possible to transfer the backed-up data to other controllers
so that they can be updated to the same status. To this end, the NC, PLC, drive and (where
applicable) HMI data can be backed up separately or together in archive files and imported
from there. Optional axis compensation data can be backed up along with NC data.
When selecting, any combinations are possible. However, it is recommended to save the
individual components separately in individual series machine startup files. It is thus possible
to reload them independently of each other and with maximum flexibility.
Note
Series machine startup data is saved in a .arc (archive) file. Where necessary, archives can
be edited using the SinuComArc tool.
The drive data is saved as binary data, which cannot be modified.
Requirement
Protection level 3 is set.
Storage locations
Archives can be stored in the following locations:
● On the CompactFlash card, under
● All configured logical drives (USB, network drives)
Compensation data
The following files are archived along with "NC data with compensation data":
● QEC - Quadrant error compensation
● CEC - Sag/angularity compensation
● EEC - Leadscrew pitch/sender error compensation
HMI sl (IM9)
Commissioning Manual, 07/2007, 6FC5397-1DP10-2BA0
/User/sinumerik/data/archive, or
/OEM/sinumerik/data/archive
11
109