Type Plates - Siemens NCU 7x0.3 PN Series Manual

3.3

Type plates

Side-mounted type plate
The following figure shows you all the information included on the type plate located on the
side of the unit.
Figure 3-2
You might need to access the information provided on the side-mounted type plate after the
equipment has been mounted. Since the type plate is located on the right-hand side of the
housing, which is the side typically used to connect to the SINAMICS S120 module, we
recommend that you make a note of the serial number of the control unit prior to assembly.
MAC addresses
A type plate for the MAC addresses of the PROFINET and Ethernet interfaces is attached to
the front panel of the Control Unit:
Figure 3-3
NCU 7x0.3 PN
Manual, 09/2011, 6FC5397-1EP40-0BA0
Type plate
MAC addresses of the PROFINET/Ethernet interfaces
Description
3.3 Type plates
21