How To Use - Hitachi DH 14DL Handling Instructions Manual

HOW TO USE

CAUTION
When using the light equipped hook, pay suffi cient
○
attention so that the main equipment does not fall. If the
tool falls, there is a risk of accident.
Do not attach the tip tool except phillips bit to the tool
○
main unit when carrying the tool main unit with the light
equipped hook suspended from a waist belt.
Injury may result if you carry the equipment suspended
from the waist belt with sharp tipped components such as
drill bit attached.
1. Using the light equipped hook
The light equipped hook can be installed on the right or left side
and the angle can be adjusted in 5 steps between 0° and 80°.
(1) Operating the hook
(a) Pull out the hook toward you in the direction of arrow (A) and
turn in the direction of arrow (B). (Fig. 9)
(b) The angle can be adjusted in 5 steps (0°, 20°, 40°, 60°,
80°).
Adjust the angle of the hook to the desired position for
use.
(2) Switching the hook position
CAUTION
Incomplete installation of the hook may result in bodily
injury when used.
(a) Securely hold the main unit and remove the screw
using a slotted head screwdriver or a coin. (Fig. 10)
(b) Remove the hook and spring. (Fig. 11)
(c) Install the hook and spring on the other side and
securely fasten with screw. (Fig. 12)
NOTE
Pay attention to the spring orientation. Install the spring with
larger diameter away from you. (Fig. 12)
(3) Using as an auxiliary light
(a) Press the switch to turn off the light.
If forgotten, the light will turn off automatically after 15
minutes.
(b) The direction of the light can be adjusted within the
range of hook positions 1 - 5. (Fig. 13)
43
English
5
4
3
2 (B)
1
Fig. 9
Fig. 10
Spring
Fig. 11
Larger
diameter
faces away
Fig. 12
Switch
Fig. 13
Hook
(A)