Product-Specifi C Safety Instructions - Bosch Rexroth LU 2 Assembly Instructions Manual

• You may operate the product only when it was found that the fi nal product (such as
a machine or system), in which the Rexroth products are installed, is in accordance
with the respective national provisions, safety regulations and the standards for the
application.
2.6 Product-specifi c safety instructions
• Do not modify or alter the product.
General
• Do not expose the product to unacceptable mechanical loads under any
circumstances. Never use the product as a handle or step. Do not place objects on it.
• Always secure the product against tipping.
• Observe the transport information on the packaging.
During transport
• Check the product for visible damage during transport.
During assembly
• Lay the cables and lines so that they cannot be damaged and no one can trip
over them.
• Make sure the relevant system component is not under pressure or voltage before
assembling the product or when connecting and disconnecting plugs.
• Secure the system component from being switched on.
• Before start-up, make sure that all seals and caps for the screwed connections are
correctly installed and undamaged to prevent fl uids and debris from infi ltrating
the product.
• Allow the product to acclimate for a few hours before start-up, otherwise
During start-up
condensation may form in the housing.
• Make sure that all electrical connections are either used or covered.
• Check the security requirements according to DIN EN 619.
• Start up the product only if it is installed completely.
• Make sure that all safety equipment belonging to the product is present,
has been installed properly, and is fully functional. Do not displace,
bypass, or disable the safety equipment.
• Do not reach into moving parts.
• Check the product for malfunctions.
• Make sure only authorized personnel perform the following within the scope of
During operation
intended use:
– Start or operate the system, or intervene in its normal functioning.
– Operate adjustment devices on components.
• Only allow persons who are authorized by the owner to access the product's direct
operating area. This also applies when the product is standing still.
• Make sure that:
– There are no obstacles preventing access to the EMERGENCY STOP control units.
– All delivery points, workstations and passages remain freely accessible.
• Do not use EMERGENCY STOP control units for routine stops.
• Regularly check the proper functioning of the EMERGENCY STOP control units.
• In the event of an error or other irregularities, after an EMERGENCY STOP turn the
product off and secure it against restarting.
• Do not reach into moving parts.
• An idle system is not a safe system, as stored energy can be released
unintentionally or through improper maintenance procedures.
Safety instructions
3 842 358 814/2017-01, MIT: LU 2, Bosch Rexroth AG
9/54