Miscellaneous functions
7.3 Measuring cycle support in the program editor (from measuring cycles SW 6.2)
Vertical softkey menu for workpiece measuring, milling
Call screen form for workpiece measurement for milling machines CYCLE977/CYCLE979
hole/shaft.
Hole/shaft and paraxial/at an angle switchover are performed in the screen form.
Call screen form for workpiece measurement for milling machines CYCLE977/CYCLE979
groove/web.
Slot/web and paraxial/at an angle switchover are performed in the screen form.
Call screen form for workpiece measurement for milling machines CYCLE978 1-point
measurement.
Call screen form for zero measurement for milling machines CYCLE998 angle measurement
1 angle/2 angle switchover is performed in the screen form.
Call screen form automatic setup corner internal/external CYCLE961.
Switchover between corner setup specifying distances and angle or points is performed
within the form.
Call vertical advancement menu.
Back to selection menu milling.
7-28
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Measuring cycles