Guideline For Card Installation - Nokia 7360 Intelligent Services Access Manager FX Series Hardware Installation Manual

Installing cards in the 7360 ISAM WM shelf

23.5 Guideline for card installation

This section provides a general guideline for the correct installation of a card in a
shelf.
Procedure 95
To install a card:
1
2
3
4
5
6
23.6 Installation procedures
This section describes the following card installation procedures:
•
•
•
•
422
Installing a card
Gently plug the card in the shelf until the front panel of the board touches the shelf. Guide the
card to the right of the slot in the shelf card guides, while taking care that the SMD
components of the card do not touch the card mounted below.
Pull back the ejector handles.
Place on thumb at the left on the front panel next to the mnemonic label and place the other
thumb on the front panel below the top ejector handle.
Push with the lower thumb and guide with the top thumb, which should cause the ejector
handles to move in.
Push both ejector handles simultaneously to completely insert the card in the shelf slot.
Lock the card in place by fastening the fixation screws.
To install power cards
To install controller cards
To install line cards
To remove cards
3HH-12893-AAAA-TCZZA
ANSI Hardware Installation Manual
DRAFT
Issue: 09