ABB PSTX Series Installation And Commissioning Manual page 98

Fieldbus Inputs/Outputs
Functions set in the Softstarter as Fieldbus digital inputs
(DI) are in fact the digital inputs to the PLC i.e. the data
flow from the Softstarter through the network to the PLC.
Fieldbus digital outputs (DO) are not configurable. The
output (DO) gives a description of data flow from the
network to the Softstarter i.e. appears as an input, from
the Softstarter point of view.
Fieldbus communication has these parameters:
Parameter
12.01 Com3 function
12.02 FB interface connector
12.03 Fieldbus control
12.04 Fieldbus address
12.05 Fieldbus ip address
12.06 Fieldbus ip gateway
12.07 Fieldbus ip netmask
12.08 Fieldbus ip dhcp client
12.09 FB baud rate*
7
12.10 FB parity
12.11 FB stop bits
98 Functions | Installation and commissioning manual |
Description
Sets the function of the Com3
port.
Sets the Fieldbus interface
selection.
Enables control from fieldbus.
Sets the Bus address.
Fieldbus IP: Sets the IP-
address.
Fieldbus IP: Sets the default
gateway.
Fieldbus IP: Sets the netmask.
Fieldbus IP: Enables dhcp.
Sets the baud rate of internal
modbus-RTU interface,
Anybus DeviceNet and Anybus
modbus-RTU.
Sets parity for Anybus modbus-
RTU.
Select stop bits for Anybus
modbus-RTU.
1SFC132081M0201
Setting range
None, Test, Modbus RTU slave,
Extension IO
FbPlug, Modbus RTU, Anybus,
None
Off, On
0 ... 65535
0.0.0.0 ... 255.255.255.255
0.0.0.0 ... 255.255.255.255
0.0.0.0 ... 255.255.255.255
Off, On
1200, 2400, 4800, 9600, 19200,
38400, 57600, 76800, 115200,
125000, 250000,500000, Auto
No parity, Odd parity, Even parity
1 Stop bit, 2 Stop bits
Default value
Test
None
Off
0
0.0.0.0
0.0.0.0
255.255.255.0
Off
* There are restrictions
on which baud rates
you can use for
different protocols. See
separate Table below.
Even parity
1 Stop bit