Panasonic LP-V Series Operation And Maintenance Manual page 215

Description
4 Duty Cycle (Only LP-W series) :
This is the ratio of laser ON time in the setting pulse cycle time.
Setting Range
Initial Value
5 Line Width :
Specifies the interval between lines at the intersection point in a character when they are crossed.
If there is a space at the intersection point of the character or it is marked too deeply, adjust this value.
Setting Range
Too large line width
Reference
• This correction is invalid for some user-registration characters.
• This correction is not effective for the logo data.
• When requiring the thicken the actual marking width, set the line width for bold character at character condition. Refer
to "4-10-2 Character Conditions" (P.180).
• The time for marking may be long if the setting value of the line width is smaller.
• The initial value of the line width is set depending on the model as follows;
LP-430/LP-420/LP-410 : 0.18mm
LP-V10 : 0.06mm
6 Marking Pitch :
This item sets the density of the marking of the bold character and bar code.
Setting Range
Bold line width
or
Module width of barcode
Reference
• The width of bold line changes when the setting value in the "Line Width" is different from that marked with laser.
• This correction is not effective for the logo data.
• It is recommended that the marking pitch is specified so that it is an integral multiple of half of the marking line width.
50 to 100%
100%
0.010 to 2.000 mm with the increment of 0.001 mm.
Line Width
LP-431/LP-421/LP-411 : 0.11mm
LP-V15 : 0.10mm
0.010 to 2.000 mm
Marking Pitch
ME-LP400V-OP-6
Line Width
Proper
LP-435/LP-425 : 0.26mm
LP-W052 : 0.04mm
Bold line width
or
Module width of barcode
Line Width
Too small line width
Marking Pitch
215