ABB RMC-100 Startup Manual page 14

J1
1 AI1 (+)
2 AI1 (GND)
3 AI2 (+)
4 AI2 (GND)
Table 11: TFIO combo digital module and extended (M2)
J1
1 POINT 1 SIG
2 POINT 1 GND
3 POINT 2 SIG
4 POINT 2 GND
J1
1 Shield
2 TC1 (J-Wht/K-Yel)
3 TC1 Red (-)
4 Shield
J1
1 OUT
2 (+)
3 (-)
4 IN
See section 9, Configuring TFIO interfaces to configure the TFIO interfaces.
5 Powering the RMC
This section describes two modes for powering the controller:
— Battery mode: power is supplied by a 12 volt battery with a charger (see section
5.2, Powering with battery and charger.)
— External power mode: power is supplied by an external power source (see
section 5.3, Powering with external power.)
Review section 5.1, Power on sequence, follow the instructions for the appropriate
power mode and continue to section 5.4, Lithium battery.
14 | 2105551-001 rev. AC
Table 10: TFIO analog input module (M2)
J2
AI3 (+)
AI3 (GND)
AI4 (+)
AI4 (GND)
J2
POINT 3 SIG
POINT 3 GND
POINT 4 SIG
POINT 4 GND
Table 12: TFIO thermocouple module (M2)
J2
Shield
TC2 (J-Wht/K-Yel)
TC2 Red (-)
Shield
Table 13: TFIO RTD module (M2)
J2
OUT
(+)
(-)
IN
J3
AI5 (+)
AI5 (GND)
AI6 (+)
AI6 (GND)
J3
POINT 5 SIG
POINT 5 GND
POINT 6 SIG
POINT 6 GND
J3
Shield
TC3 (J-Wht/K-Yel)
TC3 Red (-)
Shield
J3
OUT
(+)
(-)
IN
J4
AI7 (+)
AI7 (GND)
AI8 (+)
AI8 (GND)
J4
POINT 7 SIG
POINT 7 GND
POINT 8 SIG
POINT 8 GND
J4
Shield
TC4 (J-Wht/K-Yel)
TC4 Red (-)
Shield
J4
OUT
(+)
(-)
IN