consumption by the powered device. Power negotiation via LLDP is not supported in
static mode.
Use this command in Configuration Terminal Batch mode to manage inline power
supply in a dual-homing setup.
The following examples show power management mode, "class" configured for the
port extender 255.
Example
Dell(conf)#power inline mode pe 0 stack-unit 0 static
Dell#show power inline pe 0 stack-unit 0
Global inline power Threshold :
Power Reserved for inline Power:
Total Inline Power Consumed:
Remaining inline power Available:
Power Management Mode:
Interface
PoE Port
Priority
-------------
--------
PeGi 0/0/0
low
power inline restore pe
Enable the temporarily suspended PoE power supply to all the ports in a port extender unit.
C9000 Series
Syntax
power inline restore pe pe-id stack-unit unit number
Parameters
pe pe-id
stack-unit unit
number
Defaults
None
Command Modes
EXEC
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
Inline Power
LLDP
Max / Alloc
Support
(Watts)
------------
------
30.00/0.00
0
Enter the keyword pe and the port extender ID. Range is from 0
to 255.
Enter the keyword stack-unit and the stack-unit number.
Range is from 0 to 7.
99
841W
0W
841W
Static
Inline Power
Class
Consumed
(Watts)
------------
-------
0.00
NO_PD
Port Extenders (PE)
Device
Type
------
-
1756