Port-Channel Mode - Dell C9000 Series Reference Manual

port-channel mode

Configure the LACP port channel mode.
C9000 Series
Syntax
port-channel number mode [active] [passive] [off]
Parameters
number
active
passive
off
Defaults off
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.11.1
7.6.1.0
7.5.1.0
6.2.1.1
Usage Information LACP Modes
Enter the keywords number then a number.
Enter the keyword active to set the mode to the active state.
NOTE: LACP modes are defined in Usage Information.
Enter the keyword passive to set the mode to the passive
state.
NOTE: LACP modes are defined in Usage Information.
Enter the keyword off to set the mode to the off state.
NOTE: LACP modes are defined in Usage Information.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the Z9000.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Link Aggregation Control Protocol (LACP) 1355