Required Equipment/Tools - Sony LKRA-009 Installation Manual

1-3. Required Equipment/Tools

The equipment and tools required for this system are as follows.
Equipment/tools
Projection lens
Lamp
Dual system accessory kit
3D filter and holder
Calibration camera
Update package
Hub
Pedestal
UPS
Power cable
Exhaust system
External connection cable
Tool
Carrying handle
Luminance meter
Colorimeter
Digital Cinema Dual System
Description
Prepare the necessary lens(es) in accordance with the installation
environment.
. LKRL-Z511
. LKRL-Z514
. LKRL-Z519
t
. Be sure to use the lens of the same model for the two projectors.
. Regarding the selection of lens, contact your local Sony Sales Office/Service Center.
Prepare one of the following lamps in accordance with the installation environment.
. LKRM-U450 (6 pcs, 450 W)
. LKRM-U331 (6 pcs, 330 W)
. LKRM-U330 (6 pcs, 330 W)
n
. If all of the above number of lamps are not inserted, the projector does not operate.
. Do not mix two different lamp types (i.e., 330 W and 450 W) in a projector.
If you do so, an error will occur and the projector will not start up.
Insert the lamps of the same number and the same model in the main projector
and sub-projector.
. Regarding the selection of lamp, contact your local Sony Sales Office/Service Center.
LKRA-010
Required to configure the dual system.
LKRA-011
Required to project the 3D images.
For attaching the 3D filter and holder, the following tools are also required.
. Long screwdriver (Phillips-head)
. Socket wrench (subtense: 13 mm)
LKRA-PCAB1
Corrects the misalignment of convergence between the two projectors.
An alignment DCP is also required. (Refer to Section 6.)
Prepare all of the following software modules to configure the dual system.
. Unified Update Manager (UUM)
. Module to make the system to be recognized as the dual system
. Module to update the software to the latest version
Cisco 2960CG-8TC-L or the equivalent
To prevent an instantaneous breakdown, the switching hub should obtain power from
UPS in the same way as XCT-S10.
_
For the server
Prepare the cable that matches the plug on the installation site.
Connect the duct to the duct connecting portion on the rear top panel for exhausting
the heat inside the projector. In the case of using the 8-inch duct, the following exhaust
air volume is required.
The exhaust air volume of 450-550 ft
Refer to Section 4.
Screwdriver (for installing the lamp and server)
Handle arm (part number: 4-164-849-02)
Pipe (short) (part number: 4-164-850-02)
Pipe (long) (part number: 4-164-851-02)
CL-200 or the equivalent
PR-650 or the equivalent
3 3
/min (12.7 to 15.6 m /min) should be secured.
1-3 (E)