Related Topics
•
•
Configure Settings
•
RECOMMENDED SETTINGS
•
•
OPTIONAL SETTINGS
•
•
•
•
Before You Begin
•
Procedure
While your presentation system shows the Cisco logo and shows an IP address for your DMP, write down
the IP address.
Tip
Point your browser to the IP address that you wrote down.
Step 2
Note
78-19212-02
Understand How to Work Around the Low Signal Quality of Composite Video Cables, page 25
Configure NTP Settings for Time-Dependent Features, page 40
Establish a Wireless Network Connection, page 30
Prepare Your DMP to Use a Static IP Address Over Ethernet, page 32
Prepare Your DMP to Use a Static IP Address Over Wireless, page 34
This procedure assumes that you connected your DMP to its presentation system, and now they are
both turned On.
Later, you can change how long this splash screen is visible during startup. See the
Use HTTPS as the connection protocol. The connection fails when you use HTTP instead of HTTPS. This failure occurs
by design, to support security in your network.
43.
Getting Started Guide for Cisco Digital Media Players
Configure Settings
29