Panasonic KX-NS1000 Programming Manual page 512

10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main
Feature Guide References
2.5.4.6 Trunk Busy Out
Other PBX Extension
Other PBX extension numbers can be used to easily call extensions connected to PBXs at different locations
in a TIE line network. The leading numbers of all PBXs in the network that will be called should be entered in
this table. A maximum of 16 leading numbers can be programmed.
Dial
Specifies the leading extension number of the other PBX.
Value Range
Max. 3 digits (consisting of 0–9, *, and #)
Maintenance Console Location
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main
PC Programming Manual References
17.1 PBX Configuration—[9-1] Private Network—TIE Table—
Feature Guide References
4.3.1 TIE Line Service
KX-T7710
The settings of the MESSAGE key and One-touch keys on the KX-T7710 can be programmed.
Note
•
This tab is for programming extensions connected to legacy gateway PBXs. For information about
setting up a legacy gateway PBX, see 9.29 PBX Configuration—[1-1]
Configuration—Slot—Legacy-GW1/Legacy-GW2.
•
For further information about programming for KX-T7710 phones, refer to the documentation of the
connected legacy gateway PBX.
Dial
Indicates the DTMF tone dial required by the PBX to recognise it and dial the pre-programmed number for
each key (reference only).
Value Range
B: For MESSAGE Key
A1: For One-touch Dial 01 Key
A2: For One-touch Dial 02 Key
A3: For One-touch Dial 03 Key
A4: For One-touch Dial 04 Key
A5: For One-touch Dial 05 Key
A6: For One-touch Dial 06 Key
512 PC Programming Manual
Leading Number