Managing security
Disabling AES encryption
Perform this task to disable the encryption of data transmitted over the PTP 800
bridge. For more information on AES encryption, see
This procedure must be repeated at both ends of the link.
NOTE
To disable AES encryption, proceed as follows:
Procedure 6-18 Disable AES encryption
1
From the left hand menu, select Configuration. The System Configuration
page is displayed
Set the Encryption Algorithm attribute to 'None'
2
3
Select Submit Updated System Configuration. The Configuration Change
Reboot dialog is displayed
Select Reboot Wireless Unit. The Reboot Confirmation dialog is displayed
4
(Figure
5
Select OK. The reboot progress message is displayed. On completion, the
unit restarts with AES encryption disabled.
6-40
If AES encryption is disabled at one end of the link, it must also be
disabled at the other end of the link, otherwise the link will not work.
(Figure
6-14).
6-7).
(Figure
6-20).
Chapter 6 Operation
Security
on page
1-35
(Table
6-15).
phn-1478_005v000
Apr 2010