Display Multicast Rpf-Info - HP 3600 v2 Series Command Reference Manual

If neither all-instance nor vpn-instance is specified, this command displays information about multicast
static routes on the public network.
Examples
# Display all multicast static routes on the public network.
<Sysname> display multicast routing-table static
Multicast Routing Table of VPN-Instance: public net
Routes : 1
Mroute 10.10.0.0/16
Running Configuration = ip rpf-route-static 10.10.0.0 16 2.2.2.2 order 1
Table 14 Command output
Field
Mroute
Interface
RPF Neighbor
Route-policy
Preference
Order
Running Configuration

display multicast rpf-info

Syntax
display multicast [ all-instance | vpn-instance vpn-instance-name ] rpf-info source-address
[ group-address ] [ | { begin | exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
all-instance: Specifies all VPN instances.
vpn-instance vpn-instance-name: Specifies a VPN by its name, a case-sensitive string of 1 to 31
characters.
source-address: Specifies a multicast source address.
group-address: Specifies a multicast group address, in the range of 224.0.1.0 to 239.255.255.255.
Interface = Vlan-interface1
Matched routing protocol = <none>, Route-policy = <none>
Preference = 1, Order = 1
Description
Multicast route source address and its mask length.
Outgoing interface to the multicast source.
IP address of the RPF neighbor through which the multicast source is reachable.
Routing policy. The multicast source address of the route should match the
routing policy.
Route preference.
Sequence number of the route.
Command line that configures the multicast static route.
RPF Neighbor = 2.2.2.2
58