HP 12500 Series Configuration Manual page 125
Mpls, routing switch series
Hide thumbs
Also See for 12500 Series:
- Configuration manual (338 pages) ,
- Network management and monitoring command reference (320 pages) ,
- Command reference manual (157 pages)
Table of Contents
Advertisement
127.0.0.1/32
Configure basic MPLS TE, enable RSVP-TE and CSPF.
2.
# Configure PE 1.
[PE1] mpls lsr-id 2.2.2.2
[PE1] mpls
[PE1-mpls] lsp-trigger all
[PE1-mpls] mpls te
[PE1-mpls] mpls rsvp-te
[PE1-mpls] mpls te cspf
[PE1-mpls] quit
[PE1] interface vlan-interface 2
[PE1-Vlan-interface2] mpls
[PE1-Vlan-interface2] mpls te
[PE1-Vlan-interface2] mpls rsvp-te
[PE1-Vlan-interface2] quit
# Configure PE 2.
[PE2] mpls lsr-id 3.3.3.3
[PE2] mpls
[PE2-mpls] lsp-trigger all
[PE2-mpls] mpls te
[PE2-mpls] mpls rsvp-te
[PE2-mpls] mpls te cspf
[PE2-mpls] quit
[PE2] interface vlan-interface 2
[PE2-Vlan-interface2] mpls
[PE2-Vlan-interface2] mpls te
[PE2-Vlan-interface2] mpls rsvp-te
[PE2-Vlan-interface2] quit
Enable OSPF TE.
3.
# Configure PE 1.
[PE1] ospf
[PE1-ospf-1] opaque-capability enable
[PE1-ospf-1] area 0
[PE1-ospf-1-area-0.0.0.0] mpls-te enable
[PE1-ospf-1-area-0.0.0.0] quit
[PE1-ospf-1] quit
# Configure PE 2.
[PE2] ospf
[PE2-ospf-1] opaque-capability enable
[PE2-ospf-1] area 0
[PE2-ospf-1-area-0.0.0.0] mpls-te enable
[PE2-ospf-1-area-0.0.0.0] quit
[PE2-ospf-1] quit
Configure an MPLS TE tunnel.
4.
# Create a TE tunnel with PE 1 as the ingress node and PE 2 as the egress node. The signaling
protocol is RSVP-TE.
[PE1] interface tunnel 1
Direct 0
0
117
127.0.0.1
InLoop0
Advertisement
Table of Contents
Troubleshooting
