Mac-Address Destination-Hit Disable - HP 3600 v2 Series Command Reference Manual

interface interface-type interface-number: Specifies an outbound interface by its type and number.
Description
Use mac-address to add or modify a MAC address entry.
Use undo mac-address to remove one or all MAC address entries.
By default, no MAC address entry is configured in the system.
A static or blackhole MAC address entry will not be overwritten by a dynamic MAC address entry. A
dynamic MAC address entry can be overwritten by a static or blackhole MAC address entry.
If you execute the undo mac-address command without specifying any parameters, this command
deletes all unicast MAC address entries and static multicast MAC address entries.
You can delete all the MAC address entries (including unicast MAC address entries and static multicast
MAC address entries) of a VLAN, or you can choose to delete a specific type (dynamic, static, or
blackhole) of MAC address entries only. You can single out certain ports and delete the corresponding
unicast MAC address entries, but not the corresponding static multicast MAC address entries.
The MAC address entries configuration cannot survive a reboot unless you save it. The dynamic MAC
address table entries, however, are lost at next reboot regardless of whether or not you save the
configuration.
Related commands: display mac-address.
Examples
# Add a static entry for MAC address 000f-e201-0101. All frames destined to this MAC address are sent
out of port Ethernet 1/0/1 which belongs to VLAN 2.
<Sysname> system-view
[Sysname] mac-address static 000f-e201-0101 interface ethernet 1/0/1 vlan 2

mac-address destination-hit disable

Use mac-address destination-hit disable to disable MAC entry aging timer refresh based on destination
MAC address.
Use undo mac-address destination-hit disable to restore the default.
Syntax
mac-address destination-hit disable
undo mac-address destination-hit disable
Default
MAC entry aging timer refresh based on destination MAC address is enabled.
View
System view
Default command level:
2: System level
Examples
# Disable MAC entry aging timer refresh based on destination MAC address.
<Sysname> system-view
[Sysname] mac-address destination-hit disable
67