Toshiba strata CT Installation & Maintenance Manual page 66

Strata CT Installation
4.
5.
6.
7.
Bolt Cabinets to Wooden Floor
1.
H
Figure 2-18 Installation on Wooden Floor
2.
3.
C
Note
4.
5.
6.
Bolt Cabinets to Computer Room Floor
1.
2.
3.
Note
4.
5.
6.
2-30
Install the bolt anchors, with plugs, in the drilled holes.
Using the driving tool and a hammer, drive each bolt anchor into the floor.
Move the Base Cabinet into position on the equipment room floor.
Secure the Base Cabinet to the floor using bolts, lock washers, and flat washers.
Mount the Strata CT Base Cabinet on Floor Mount Fixtures (BFIF). See
and 2-16.
Base
Cabinet
BFIF
(Floor
mount
fixture)
Wooden
Floor
Position the Base Cabinet at the selected installation location.
Mark the floor where holes will be drilled. Move the Base Cabinet prior to drilling.
Cover the Base Cabinet with a drop cloth to protect the power equipment from dust
created during drilling.
Drill pilot holes to make insertion of 3/8 inch lag bolts easier, and to prevent splitting of
wood flooring.
Move the Base Cabinet into position on the equipment room floor.
Secure the Base Cabinet to the floor using lag bolts, lock washers, and flat washers
Mount the Strata CT Base Cabinet on Floor Mount Fixtures (BIMF). See
and 2-16.
Position the Base Cabinet at the selected installation location.
Mark the floor where holes will be drilled. Move the Base Cabinet prior to drilling.
Cover the Base Cabinet with a drop cloth to protect the power equipment from dust
created during drilling.
Drill holes through tile for 3/8-inch threaded rods.
After the tiles have been drilled, insert threaded rods through the holes in the tile and
mark the concrete floor directly beneath the holes in the tiles.
Remove the tiles. Use a hammer drill to make holes for 3/8-inch bolt anchors.
Bolt
Lockwasher
1468
Strata CT I&M Manual October 2000
Figures 2-15
Figures 2-15