Siemens GIGASET SL55 Manual page 71

System settings
Activating/deactivating internal call diversion
Requirement: Internal call diversion can only be activated if a destination has been set
up.
¢
v w Ð
/
either ...
Activate?
or ...
Deactivate?
Specifying the number of ringing cycles
Ring delay can be used to specify the number of ring cycles after which a call is to be
diverted. The setting can be between 0 (= immediate call diversion) and 9 rings.
A ring cycle lasts 5 seconds.
¢
v w Ð
/
~
OK
Diverting calls externally – CF (Call Forwarding)
Your ISDN connection provides 2 telephone lines (B channels) that you can use at the
same time. It is therefore possible to activate call diversion not only in the telephone
exchange (external), but also directly in the base station (internal). A caller is forwarded
to the destination you specify via the second telephone line. You can set the location for
call diversion as follows:
so that the call is diverted in the telephone exchange (external call diversion);
◆
this keeps your telephone lines free;
so that the call is diverted in your base station (internal call diversion); this means
◆
both telephone lines are engaged.
◆
◆
i
◆
◆
For each receive MSN you can store a destination number for each of the following con-
ditions:
Immediately – On busy – On no reply
External call diversions set up are entered in a list. Active call diversions are identified in
this list.
70
¢ ¢
Base Forward. base
To activate:
Confirm.
OK
To deactivate:
Select and confirm.
OK
¢ ¢
Base Forward. base
Enter the number of ring cycles and confirm.
You pay the costs of the call diversion.
If the call is diverted in the base station (internal call diversion), then
the condition "When busy" is not available.
All three conditions can be activated at the same time.
If night service has been set up for a receive MSN (page 63), external
call diversion cannot be set up or changed for this receive MSN.
¢
No. of rings