Removing Or Modifying A Port Mirroring Session; Telnet Sessions; Figure 26: Telnet Session Configuration - D-Link DWL-8600AP User Manual

D-Link UWS User Manual

Telnet Sessions

Removing or Modifying a Port Mirroring Session

1. From the Port Mirroring page, click Remove Source Port.
2. Select one or more source ports to remove from the session.
Use the CTRL key to select multiple ports to remove.
3. Click Remove.
The source ports are removed from the port mirroring session, and the device is updated.
Telnet Sessions
Telnet is a terminal emulation TCP/IP protocol. ASCII terminals can be virtually connected to the local device
through a TCP/IP protocol network. Telnet is an alternative to a local login terminal where a remote login is
required.
The switch supports up to five simultaneous telnet sessions. All CLI commands can be used over a telnet
session.
The Telnet Session Configuration page allows you to control inbound telnet settings on the switch. Inbound
telnet sessions originate on a remote system and allow a user on that system to connect to the switch CLI. To
configure outbound telnet settings, which are telnet sessions that originate on the switch to access a remote
system, see "Outbound Telnet Client Configuration" on page 94.
To display the Telnet Session Configuration page, click LAN > Administration > Telnet Session in the navigation
tree.

Figure 26: Telnet Session Configuration

Unified Wired and Wireless Access System
D-Link
Oct. 2015 Page 92