Philips SOPHO SuperVisor 25 Engineer's Manual page 21

Projecting for the model 25-S
are discussed in this section.
There is a difference in projecting between the following Software packages in the ISPBXs:
- Product Release 200 or 205 and System Software 300.
- Product Release 735 and System Software 740, 741 and 8xx.
For projecting, check which System Software (or Product Release) and PMC package are
present in your system and which hardware interface is used. In
PR/SSW, HW interface and PMC package."
table is used in the sections
ISPBX". The items in the "action" column have the following meaning:
- no action
- 280E
- 1905
- not possible
*)
and model 35 is the same, as far as it concerns the items which
0
a number of combinations have been given. This
2.5. "PROJECTING MODEL 25-S0 AND MODEL 35 IN THE
Continue with the next paragraph of the section where was
referred to this table
In this signalling group, the parameter of bit 1 must be set to "2"
with PE command 4401: for the meaning of this bit, see
"Byte Numbers and their Values, Ranges and Meanings."
In this signalling group, the parameter of bit 0 must be set to "0" and
of bit 1 to "1". Use the OM command CHPMPD: for the meaning
of these bits, see Table 2-3 "Byte Numbers and their Values,
Ranges and Meanings."
This combination of hardware and software interface is not
posssible. The PMC package must be updated
PPU-741.4 consists of the PPU PROM packages 154.4/254.4 and
the PMC packages 401.4/501.4
Table 2-2 "Relations between
Table 2-3
19