GE 745 Instruction Manual page 236

TARGET AND FLASH MESSAGES
6–28
ENTRY MISMATCH –
CODE NOT STORED
INPUT FUNCTION IS
ALREADY ASSIGNED
INVALID KEY: MUST
BE IN LOCAL MODE
INVALID SERIAL
NUMBER
NEW PASSCODE HAS
BEEN STORED
NEW SETPOINT HAS
BEEN STORED
NO ACTIVE TARGETS
(TESTING LEDS)
OUT OF RANGE –
VALUE NOT STORED
PASSCODE VALID -
OPTIONS ADJUSTED
PLEASE ENTER A
NON-ZERO PASSCODE
CHAPTER 6: ACTUAL VALUES
This flash message is displayed while changing the
programmed passcode from the change passcode
command. If the passcode entered at the prompt
PLEASE RE-ENTER NEW PASSCODE is different
one entered at the prompt
PASSCODE , the 745 will not store the entered
passcode, and display this flash message.
(a) This flash message is displayed under certain
conditions when attempting to assign logic input
functions under
S3 LOGIC INPUTS
and "To FlexLogic" functions can be assigned to more
than one logic input. If an attempt is made to assign
any another function to a logic input when it is already
assigned to another logic input, the assignment will
not be made and this message will be displayed,
(b) Ground Input Selection settings also use this flash
message.
This flash message is displayed in response to pressing
RESET while the 745 is in remote mode. The 745 must
be put into local mode in order for this key to be
operational.
This flash message is displayed when an attempt is
made to upgrade installed options and the 745 detects
an invalid serial number.
This flash message is displayed in response to
changing the programmed passcode from the
setpoint
S1 745 SETUP PASSCODE

. The directions to change the passcode
PASSCODE
were followed correctly, and the new passcode was
stored as entered.
This flash message is displayed in response to pressing
ENTER while editing on any setpoint message. The
edited value was stored as entered.
This flash message is displayed in response to the
MESSAGE UP or DOWN key while the Message LED is
off. There are no active conditions to display in the
target message queue.
This flash message is displayed in response to pressing
ENTER while on a setpoint message with a numerical
value. The edited value was either less than the
minimum or greater than the maximum acceptable
value for this setpoint and, as a result, was not stored.
This flash message is displayed when an attempt to
upgrade an option was successful.
This flash message is displayed while changing the
passcode from the
S1 745 SETUP
setpoint. An attempt was made to
CHANGE PASSCODE
change the passcode to "0" when it was already 0.
745 TRANSFORMER PROTECTION SYSTEM – INSTRUCTION MANUAL
from the
PLEASE ENTER A NEW
. Only the "Disabled"
CHANGE

PASSCODE
 