Adjusting The Overlap Of The Sensor Flag - Toshiba e-studio200l Service Handbook

3.12.3

Adjusting the overlap of the sensor flag

If the overlap between the sensor and the flag is wrong for some reason, perform the following adjust-
ment.
<Procedure>
(1) Remove the processing tray unit.
(2) Loosen the mounting screw of the front/rear
jogging plate adjusting plate; then, move the
adjusting plate to the left and the right.
(3) Tighten the screw so that the overlap
between the flag of the front/rear jogging
rack plate and the sensor is 1.5 mm to 2.0
mm.
e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
ADJUSTMENT
Jogging plate
adjusting plate
Adjusting
plate
Screw
Sensor
1.5 mm to 2.0 mm
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved
3 - 88
Screw
Jogging plate
Adjusting
adjusting plate
plate
Fig. 3-116
Sensor flag
Fig. 3-117