Remove Replication-Volume - HP P2000 G3 Cli Reference Manual

remove replication-volume

Description Removes a secondary volume from a replication set. The secondary volume is converted to a master
volume. Any replication snapshots associated with that volume are converted to standard snapshots,
regardless of the number of snapshots allowed by the system's license.
You must run this command on the primary system. You cannot remove the primary volume.
Syntax
remove replication-volume
[nowait]
[primary-volume volume]
[set replication-set]
replication-volume
Parameters nowait
Optional. Removing a volume from a replication set can take the Storage Controller several minutes
to complete. This parameter allows that processing to continue in the background so the
Management Controller can process other commands.
primary-volume volume
Optional; use only if the replication set has a primary-volume conflict. Name or serial number of the
primary volume.
set replication-set
Optional. Name or serial number of the replication set.
replication-volume
Name or serial number of the secondary volume to remove. If the name is not unique within the
replication set, the volume that is not the primary volume is removed. If the name is not unique across
replication sets, specify the set parameter.
Example Remove secondary volume rData from a replication set:
# remove replication-volume rData
Info: Started removing the secondary volume from the replication set. (rData)
Info: Verifying that the secondary volume was removed from the replication set.
This may take a couple of minutes... (rData)
Info: The secondary volume was removed from the replication set. (rData)
Success: Command completed successfully. (2012-01-21 12:53:33)
See also • show replication-sets
• show replication-volumes
HP P2000 G3 MSA System CLI Reference Guide 111