Toshiba 1600EP SERIES Instruction Manual page 39

Data Setting Screens (Cont'd)
The following screens show the procedure for setting the data variables. They are accessed from the
main 'Data Setting Screens' (see
The Keylock function
allows the operator to
disable the RUN + STOP
button functions. When
this function is set to EN
the unit will remain in the
operating mode it was in
when enabled and will not
be able to be changed
with the RUN + STOP
buttons until this function is
disabled. With this function
set to DIS, the RUN +
STOP buttons function
normally. The default
setting is DIS.
2 = High
1 = Low
0 = Off
Default setting is 2 = High
(loudest)
Displays the number of
minutes (3 or 30) of idle
time before the LCD will
go blank (this is to prolong
LCD life). The LCD will be
active again once a display
button is pressed. Default
setting is 3 min.
If set to YES, the unit will
automatically
start up in the UPS
mode (on line) when
input voltage is applied,
regardless of what mode it
was in when shut down.
Default setting is NO.
1600EP Series Instruction Manual
page 38) when the "SHIFT/SELECT" key is pressed:
DEFAULT SETTINGS
PUSH: SELECT
DEFAULT SETTINGS
PUSH: SELECT
Loops through both
possibilities
BUZZER VOLUME: 2
TO ACCEPT: SET
BUZZER VOLUME: 0
TO ACCEPT: SET
BUZZER VOLUME: 1
TO ACCEPT: SET
Loops through three
possibilities
LCD SLEEP: 3MIN
TO ACCEPT: SET
LCD SLEEP:30MIN
TO ACCEPT:SET
Loops through both
possibilities
AUTO RUN: YES
TO ACCEPT:SET
AUTO RUN: NO
TO ACCEPT:SET
Loops through both
possibilities
Shift
Set
KEY LOCK: DIS
+
TO CHANGE: SELECT
Monitor
Select
Shift
Set
+
TO CHANGE:SELECT
Monitor
Select
Returns to Data Setting
Screens (with new value
Shift
Set
BUZZER VOLUME:2
+
TO CHANGE: SELECT
Monitor
Select
Shift
Set
BUZZER VOLUME: 0
+
TO CHAGNE:SELECT
Monitor
Select
Shift
Set
BUZZER VOLUME: 1
+
Monitor
TO CHANGE: SELECT
Select
Returns to Data Settings
Screens (with new value
applied)
Shift
Set
+
TO CHANGE: SELECT
Monitor
Select
Shift
Set
+
Monitor TO CHANGE:SELECT
Select
Returns to Data Setting
Screens (with new value
Shift
Set
AUTO RUN: YES
+
TO CHANGE: SELECT
Monitor
Select
Shift
Set
AUTO RUN: NO
+
TO CHANGE:SELECT
Monitor
Select
Returns to Data Setting
Screens (with new value
KEY LCOK:EN
applied)
LCD SLEEP: 3MIN
LCD SLEEP:30MIN
applied)
applied)
39