Charger Wire - Toshiba e-STUDIO182 Service Manual

10.7.13 Charger wire

* Length: 353 mm (tungsten wire), diameter: 0.06 mm
(1) Take off the transfer/separation charger.
P.10-16 "10.7.12 Transfer/Separation
charger"
(2) Release 9 latches and take off the separation
supporter.
(3) Release 2 latches and take off the terminal
cover on the front side.
(4) Release 2 latches and take off the terminal
cover on the rear side.
(5) Remove the terminal and spring. Then take
off the transfer charger wire.
(6) Remove the cushioning material, disconnect
the terminal and remove the spring. Then
take off the separation charger wire.
Notes:
1. Insert the wire securely into the V-
grooves of the front and rear sides.
2. Do not twist the wire.
3. Do not touch the wire directly with bare
hands.
© 2009 TOSHIBA TEC CORPORATION All rights reserved
Separation supporter
Fig. 10-28
Terminal cover
Fig. 10-29
Cushioning material
Terminal
Spring
Transfer charger wire
Fig. 10-30
10 - 17
Separation charger wire
e-STUDIO182/212/242
DRUM RELATED SECTION
10