Feed Gear Unit; Drawer Detection Switch (Sw5) - Toshiba e-STUDIO182 Service Manual

9.5.18

Feed gear unit

(1) Take off the main motor drive unit.
P.8-7 "8.5.3 Main motor drive unit"
(2) Take off the registration clutch.
P.9-20 "9.5.13 Registration clutch (CLT1)"
(3) Take off the pickup solenoid bracket.
P.9-20 "9.5.14 Pickup solenoid (SOL1)"
(4) Remove 2 screws, and then take off the feed
gear unit.
9.5.19

Drawer detection switch (SW5)

(1) Take off the damp heater unit or dummy
plate.
P.9-18 "9.5.10 Damp heater unit (DH3) /
Dummy plate"
(2) Release the latch, take off the bracket while
lifting it up, and then disconnect the
connector.
(3) Release the latch and take off the drawer
detection switch from the bracket.
e-STUDIO182/212/242
PAPER FEEDING SYSTEM
Feed gear unit
Connector
Drawer detection switch bracket
Drawer detection switch
© 2009 TOSHIBA TEC CORPORATION All rights reserved
9 - 24
Fig. 9-49
Latch
Drawer detection
switch bracket
Fig. 9-50
Fig. 9-51