G 848; Programming Mode; Table 6-7: G 848 Programming Flow Chart; Table 6-8: G 848 Programming Functions - Miele G 600 Series Technical Information

Technical Information
6.8.2

G 848

Enter Programming Mode
Enter Service Mode 1
Enter Service Mode 2

Table 6-7: G 848 Programming Flow Chart

6.8.2.1

Programming Mode

1. To access the programming mode, close the door and turn the program
selector switch to Stop. Turn the dishwasher off.
2. Press and hold the Start button while turning the dishwasher on. Release the
Start button within 2 seconds. A blinking Salt light indicates successful
accessing of the programming mode.
3. Turn the program selector switch to the position indicated in Table 6-8 to modify
the corresponding function.
4. Use the Start button to toggle the functions on or off.
5. After selecting options, turn the program selector switch to Stop and turn the
dishwasher off.
Selector switch
position (o'clock)
1 to 8
9
11

Table 6-8: G 848 Programming Functions

1
If no lights light up, the dishwasher is programmed for "without water softener". To change to
"with water softener", follow the steps in Service Mode 2 (Section 6.8.2.3).
2
Factory setting
Programming Flow Chart
To access:
Water hardness settings
Extended drying 4.5 - 14 minutes
Water intake time
To access:
Manual step mode
Component test program
To access:
Error messages
Program index
Increased water temperature selection
Water softener (with/without)
Interim rinses
Extended drying 14 - 45 minutes
Dishwasher width setting
Function
Water hardness
Extended drying
Water intake time
86
Options
See Section 6.8.2.1.1 Light 1 to 8 on
2
On
Off
2
70 seconds
100 seconds
G 600/G 800
Status of Start light
1
Off
On
Off = 70 sec
On = 100 sec