G 600/G 800
Fault code
F00
F01
F02
F03
F04
F05
F06
F07
F08
F09
3 dashes (---) in display
Table 6-38: G 890 Fault Code Chart
1
All wash programs can be run, but the heating element will not function during the cycle.
6.8.7.3.2
Deleting Stored Fault Codes
Access Programming Mode and press Start/Stop twice.
6.8.7.3.3
Operating Hours
1. Access Service Mode 2.
2. Press the appropriate program button indicated in Table 6-39 to display operating hours.
Program button
Sani Wash
Normal Plus
Table 6-39: G 890 Operating Hours
Example:
Sani Wash: 007
Normal Plus: 127
Total operating hours: 7.127 hours
6.8.8
G 891
Enter Programming Mode
Enter Service Mode 1
Fault
No error
NTC or NTC connections open-circuited
NTC or NTC connections short-circuited
Electronic failure, selector switch position not found
Heating failure - heating circuit opened or defective
electrical component in heating circuit
Water drainage failure, heater level switch
Too few pulses at flow meter / start of water intake
Too few pulses at flow meter / end of water intake
Water intake failure, heater level switch
Heater level switch not switching on at the end of thermal stops
Indicates a F1, F2, F4, or F9 fault is stored in the memory
Display
First 3 digits of total operating hours
Last 3 digits of total operating hours
Programming Flow Chart
To access:
Program index
Water hardness settings
Extended drying fan time (+14 min)
Buzzer
To access:
Manual step mode
Component test program
107
Technical Information
1