Epson PP-1002 User Manual page 7

Install this product in the following type of place.
Place that is flat and stable
Flat
• When using this product in a place where static electricity is easily generated, use an
antistatic mat or other product to prevent static electricity.
• Do not install on a surface that is smaller than the base of the product.
If the rubber feet on the bottom of the product extend beyond the surface the product is
installed on, it places stress on the internal mechanisms, which negatively affects disc
writing, printing and transporting. Be sure to install on a flat surface that is wider than the
product so that all of the feet on the base of the product rest firmly on it.
Do not block the air vents on this product.
Blocking the air vents may result in internal heat build-up and fire.
Do not install in the following types of places.
WARNING
• Tight spaces where ventilation is poor, such as in a closet or on a bookshelf
• On a rug or bed
If you place the product by a wall, leave more than 10 cm between the back
of the product and the wall. It is also necessary to leave enough space in front
of the product to open and close the disc cover.
Do not install in a place where volatile substances, such as alcohol or paint
thinner, are present or in a place where there is fire.
This may result in electric shock or fire.
Do not install or store in an unstable place (such as on a wobbly or tilted
surface), in reach of children, or in a place subject to vibration from other
machines.
CAUTION
There is a risk that it could drop or fall over, resulting in injury.
Do not install in places where there is excessive moisture or dust, risk of getting
wet, direct sunlight, severe changes in temperature and humidity, or close to
heating and cooling devices.
There is a risk of electric shock, fire, and malfunction or failure of this product.
Place with the following temperature and
humidity range
Before Using this Product
7