Epson PP-1002 User Manual page 67

3 Make sure that discs are loaded in the input stacker correctly.
See "Loading Discs" on page
4
Click Publish.
EPSON Total Disc Utility starts, and the disc publishing process begins.
• With the PP-100II,
Stacker 4 without pausing the job. However, when the BUSY light is flashing rapidly, do
not pull out Stacker 4 because discs are being output to Stacker 4. Doing so may
damage the discs.
• Once the output stacker becomes full, the job is paused. The job is resumed
automatically if you take out the published discs and close the disc cover/stacker 4.
• If the Mac shuts down while processing a job, all the jobs are cancelled.
• For PP-100II/PP-100
∗ Do not open the disc cover while a job is being processed (while the BUSY light is
flashing). This could adversely affect the writing or printing quality.
∗ If a job is being processed (while the BUSY light is flashing) and you need to open the
disc cover to load or take out discs, first pause the job and then open the disc cover.
See "Pausing/Cancelling Jobs" on page 73
∗ If you open the disc cover while a job is being processed (while the BUSY light is
flashing), an alarm beep sounds and the current job enters the standby status.
Closing the disc cover automatically resumes the job.
∗ While an alarm beep is sounding, the arm is moving. To ensure safety, do not put your
hands inside the product. Also, do not operate any stackers while an alarm beep is
sounding. This could damage the arm.
• For PP-100AP
∗ If you open the disc cover while a job is being processed (while the BUSY light is
flashing), make sure the internal light has turned off and that the arm has stopped
moving before performing any operation, such as loading or taking out discs. Do not
put your hands inside the product or operate any stackers while the arm is moving.
Also, open and close the disc cover gently.
∗ If you open the disc cover while a job is being processed (while the BUSY light is
flashing), the current job enters the standby status. Closing the disc cover
automatically resumes the job.
• For PP-50
∗ If you open the disc cover while a job is being processed (while the BUSY light is
flashing), make sure the internal light has turned off and that the arm has stopped
moving before performing any operation, such as loading or taking out discs. Do not
put your hands inside the product or operate any stackers while the arm is moving.
Also, open and close the disc cover gently.
∗ If you open the disc cover while a job is being processed (while the BUSY light is
flashing), the current job enters the standby status. Closing the disc cover
automatically resumes the job.
61.
PP-100, or PP-100AP , you can take out the published discs output to
for the procedure to pause a job.
Publishing Discs
67